GM Cavalier/Sunbird/Skyhawk/Firenza 1982-1994

Power Seat Motors

Print

REMOVAL & INSTALLATION



  1. Remove the front seat assembly and place upside down on a clean surface.
  2.  
  3. Disconnect the motor feed wires from the motor.
  4.  
  5. Remove the nut securing the front of the motor support bracket to the inboard adjuster and withdraw the assembly from the adjuster and the gear nut drives.
  6.  
  7. Disconnect the drive cables from the motor and complete the removal of the support bracket with motors attached.
  8.  
  9. Grind off the peened over ends(s) of the grommet assembly securing the motor to the support and separate the motors from the support, as required.
  10.  
  11. To install, reverse the removal procedure except as noted:
    1. Drill out the top end of the grommet assembly using a 3 / 16 in. (5mm) drill.
    2.  
    3. Install the grommet assembly to the motor support bracket and secure the motor to the grommet using a 3 / 16 in. (5mm) rivet.
    4.  

  12.  

 
label.common.footer.alt.autozoneLogo