GM Celebrity/Century/Ciera/6000 1982-1996 Repair Guide

Electric Window Motor

Print

REMOVAL & INSTALLATION



  1. Remove the door trim panel and inner panel water deflector.
  2.  
  3. Raise the window to the full up position and tape the glass to the door frame using cloth-backed tape.
  4.  
  5. Disconnect the negative battery cable.
  6.  
  7. Remove the lower sash bolts.
  8.  
  9. Punch out the center pins of the regulator rivet. Drill out rivets using 1 / 4 in. (6mm) drill bit.
  10.  
  11. Move regulator and motor assembly rearward, then remove the electrical connector.
  12.  
  13. With the regulator in the door, drill out the regulator-to-motor rivets using a 1 / 6 in. (4mm) drill bit, then remove the motor.
  14.  

To install:
  1. Install and connect the window motor.
  2.  
  3. Use 3 / 16 in. (5mm) rivets or 3 / 16 in. (5mm) nuts and bolts to install the motor to the regulator.
  4.  
  5. Connect the electrical wiring, then install the regulator and door inner panel using a 1 / 4 in. (6mm) rivets.
  6.  
  7. Install the lower sash bolts, tighten to 62 inch lbs. (7 Nm).
  8.  
  9. Install the water deflector and remove the tape from the window.
  10.  
  11. Connect the negative battery cable, reset the clock and radio.
  12.  

 
label.common.footer.alt.autozoneLogo