GM Celebrity/Century/Ciera/6000 1982-1996 Repair Guide

Power Seat Motor

Print

REMOVAL & INSTALLATION



  1. Position the seat in the full forward position. If the car is equipped with six-way power seats, place the seat in the full forward and up position. When necessary to gain access to the adjuster-to-floor pan attaching nuts, remove the adjuster rear foot covers and or carpet retainers.
  2.  
  3. Remove the track covers where necessary, then remove the adjuster-to-floor pan rear attaching nuts. Position the seat in the full rearward position.
  4.  
  5. Remove the adjuster front foot covers, then remove the adjuster to floor pan front attaching nuts. Tilt the seat rearward and disconnect the feed wire connector.
  6.  
  7. Remove the seat assembly from the car.
  8.  
  9. Place the seat up side down on a clean surface.
  10.  
  11. Disconnect the vertical and horizontal drive cables from the motor.
  12.  
  13. Remove the retainer nut from the motor support bracket.
  14.  
  15. Remove the motor from the seat.
  16.  

To install:
  1. Position the motor in the motor support bracket.
  2.  
  3. Connect the vertical and horizontal drive cables.
  4.  
  5. Place the seat into the vehicle and connect the feed wire.
  6.  
  7. Position the seat in the position that makes installation of the retaining nuts easiest. Install the adjuster to floor pan attaching nuts, tighten to 15-21 ft. lbs. (20-28 Nm), then install the foot covers.
  8.  

 
label.common.footer.alt.autozoneLogo