GM Century/Lumina/Grand Prix/Intrigue 1997-2000

Engine Start-up and Break-in

Print

STARTING THE ENGINE



With the engine installed and every wire and hose is properly connected, take the time to go back and double check that all coolant and vacuum hoses are connected. Check that your oil drain plug is installed and properly tightened. If not already done, install a new oil filter onto the engine. Fill the crankcase with the proper amount and grade of engine oil. Fill the cooling system with a 50/50 mixture of coolant/water.

  1. Connect the vehicle battery.
  2.  
  3. Start the engine. Keep your eye on your oil pressure indicator; if it does not indicate oil pressure within 10 seconds of starting, turn the vehicle off.
  4.  


WARNING
Damage to the engine can result if it is allowed to run with no oil pressure. Check the engine oil level to make sure that it is full. Check for any leaks and if found, repair the leaks before continuing. If there is still no indication of oil pressure, you may need to prime the system.

  1. Confirm that there are no fluid leaks (oil or other).
  2.  
  3. Allow the engine to reach normal operating temperature (the upper radiator hose will be hot to the touch).
  4.  
  5. At this point you can perform any necessary checks or adjustments, such as checking the ignition timing.
  6.  
  7. Install any remaining components or body panels which were removed.
  8.  

ENGINE BREAK-IN



Make the first miles on the new engine, easy ones. Vary the speed but do not accelerate hard. Most importantly, do not lug the engine, and avoid sustained high speeds until at least 100 miles. Check the engine oil and coolant levels frequently. Expect the engine to use a little oil until the piston rings seat. Change the oil and filter at 500 miles, 1500 miles, then every 3000 miles after that.

 
label.common.footer.alt.autozoneLogo