GM Corsica/Beretta 1988-1996 Repair Guide

Hydraulic Modulator Solenoid Assembly

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Detach the solenoid electrical connector.
  4.  
  5. Remove the Torx® head bolts.
  6.  
  7. Remove the solenoid assembly.
  8.  



Click image to see an enlarged view

Fig. Fig. 1: Exploded view of the hydraulic module solenoid mounting

To install:
  1. Lubricate the O-rings on the new solenoid with clean brake fluid.
  2.  
  3. Position the solenoid so the connectors face each other.
  4.  
  5. Press down firmly by hand until the solenoid assembly flange seats on the modulator assembly.
  6.  
  7. Install the Torx® head bolts and tighten to 39 inch lbs. (5 Nm).
  8.  
  9. Attach the solenoid electrical connector.
  10.  
  11. Properly bleed the brake system.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo