GM Corsica/Beretta 1988-1996 Repair Guide

Clutch Start Switch

Print

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Locate the switch on the clutch pedal support.
  4.  
  5. Detach the electrical connector from the switch and remove the switch by removing the nut from the stud.
  6.  

To install:
  1. Install the switch on the stud and tighten the retaining nut to 53 inch lbs. (6 Nm).
  2.  
  3. Attach the electrical harness to the switch.
  4.  
  5. Connect the negative battery cable and verify that the starter engages only when the clutch is fully engaged.
  6.  

 
label.common.footer.alt.autozoneLogo