GM Corsica/Beretta 1988-1996 Repair Guide

Body Lubrication and Maintenance

Print

Every 12 months or 7,500 miles (12,000km.), the various linkages and hinges on the chassis and body should be lubricated, as follows:

TRANSAXLE SHIFT LINKAGE



Lubricate the manual transaxle shift linkage contact points with the EP grease used for chassis greasing, which should meet GM specification 6031M. The automatic transaxle linkage should be lubricated with clean engine oil.

HOOD LATCH AND HINGES



Clean the latch surfaces and apply clean engine oil to the latch pilot bolts and the spring anchor. Use the engine oil to lubricate the hood hinges as well. Use a chassis grease to lubricate all the pivot points in the latch release mechanism.

DOOR HINGES



The gas tank filler door, car door, and rear hatch or trunk lid hinges should be wiped clean and lubricated with clean engine oil. Silicone spray also works well on these parts, but must be applied more often. Use engine oil to lubricate the trunk or hatch lock mechanism and the lock bolt and striker. The door lock cylinders can be lubricated easily with a shot of silicone spray or one of the may dry penetrating lubricants commercially available.

PARKING BRAKE LINKAGE



Use chassis grease on the parking brake cable where it contacts the guides, links, levers, and pulleys. The grease should be a water resistant one for durability under the car.

ACCELERATOR LINKAGE



Lubricate the carburetor stud, carburetor lever, and the accelerator pedal lever at the support inside the car with clean engine oil.

 
label.common.footer.alt.autozoneLogo