GM Corsica/Beretta 1988-1996 Repair Guide

Headlight Switch

Print

REMOVAL & INSTALLATION



1988-90 Vehicles

See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the switch by gently prying behind the switch.
  4.  
  5. Pull the switch away from the instrument panel, then detach the wiring.
  6.  
  7. Remove the switch from the vehicle.
  8.  



Click image to see an enlarged view

Fig. Fig. 1: Exploded view of the headlight switch mounting - 1988-90 vehicles

To install:
  1. Attach the wires to the new switch and press it into the instrument panel, making sure it is properly seated.
  2.  
  3. Connect the negative battery cable, then test for proper switch operation.
  4.  

1991-96 Vehicles
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the instrument cluster bezel/trim panel.
  4.  
  5. Squeeze the small knob at the side and pull it straight out.
  6.  
  7. Insert a small flat-bladed tool into the slots adjacent to the center of the inner knob to disengage the knob from the switch.
  8.  
  9. Unfasten the screws attaching the headlight switch to the bezel.
  10.  
  11. Remove the switch from the vehicle.
  12.  

To install:
  1. Install the switch to the bezel. Install the attaching screws.
  2.  
  3. Position the inner knob on the switch. Ensure the tabs are lined up with the slots and press to secure the knob.
  4.  
  5. Position the outer knob on the switch and align the D-shaped hole in the knob to the shaft on the switch and press to secure the knob.
  6.  
  7. Install the instrument cluster bezel.
  8.  
  9. Connect the negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo