GM Corsica/Beretta 1988-1996 Repair Guide

Fuel Pressure Connection

Imprimir

REMOVAL & INSTALLATION



See Figure 1

  1. Properly relieve the fuel system pressure.
  2.  
  3. If not done already, disconnect the negative battery cable.
  4.  
  5. Remove the fuel pressure connection and seal. Discard the seal.
  6.  



Click image to see an enlarged view

Fig. Fig. 1: Exploded view of the fuel pressure connection

To install:
  1. Place a new seal on the fuel pressure connection.
  2.  
  3. Place the fuel pressure connection in the fuel rail. Tighten the fuel pressure connection 88 inch lbs. (10 Nm).
  4.  
  5. Tighten the fuel filler cap.
  6.  
  7. Connect the negative battery cable and turn the ignition ON for 2 seconds, OFF for 10 seconds, then ON and check for fuel leaks.
  8.  

 
label.common.footer.alt.autozoneLogo