GM Corvette 1984-1996 Repair Guide

Outside Mirrors

Print

REMOVAL & INSTALLATION



1984-88 Vehicles

See Figure 1

  1. Roll the window down, remove the door trim panel and water deflector.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Unfasten the clips holding the electrical wiring to the door.
  6.  
  7. Remove the 2 attaching nuts, then remove the mirror from the vehicle.
  8.  



Click image to see an enlarged view

Fig. Fig. 1: Outside power mirror mounting-1988 vehicle shown

  1. Installation is the reverse of the removal procedure.
  2.  

1989-96 Vehicles

See Figure 2

  1. Lower the window.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the door trim panel and water deflector.
  6.  
  7. Either remove the accessory mounting plate screws, or partially remove the inner mounting panel for access to the mirror electrical connectors.
  8.  
  9. Remove the mirror wiring harness retainer.
  10.  
  11. Detach the mirror electrical connector.
  12.  
  13. Unfasten the retaining nuts, then remove the mirror from the door. Make sure to note the mirrors wire harness routing. Convertibles are equipped with wind deflectors which are attached to the mirrors. The wind deflectors must be installed.
  14.  



Click image to see an enlarged view

Fig. Fig. 2: Power outside mirror mounting-1993 vehicle shown, others similar

  1. Installation is the reverse of the removal procedure.
  2.  

 
label.common.footer.alt.autozoneLogo