GM Corvette 1984-1996 Repair Guide

Blower Motor

Print

REMOVAL & INSTALLATION



See Figures 1, 2, 3, 4, 5, and 6

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the front wheel house rear panel and seal.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: You must unfasten the inner fender well Torx® retaining bolts

  1. Detach the blower motor electrical connector(s).
  2.  



Click image to see an enlarged view

Fig. Fig. 2: Unplug the blower motor electrical connector



Click image to see an enlarged view

Fig. Fig. 3: Make sure you detach all of the necessary connectors

  1. Remove the blower motor cooling tube.
  2.  



Click image to see an enlarged view

Fig. Fig. 4: Disconnect the cooling tube from the blower motor

  1. Unfasten the necessary retainers, then remove the blower motor and fan from the evaporator case.
  2.  



Click image to see an enlarged view

Fig. Fig. 5: Unfasten the blower motor retaining bolts ... ... then pull the blower motor from the mounting case



Click image to see an enlarged view

Fig. Fig. 6: Exploded view of the blower motor and evaporator case-1996 vehicle shown, other years similar

  1. Installation is the reverse of the removal procedure.
  2.  

 
label.common.footer.alt.autozoneLogo