GM Corvette 1984-1996 Repair Guide

Windshield Wiper Switch

Print

REMOVAL & INSTALLATION



1984-89 Vehicles

On 1984-89 vehicles, the windshield wiper switch is located on the drivers side door panel.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the armrest and filler from the door panel.
  4.  
  5. Remove the accessory trim plate.
  6.  
  7. If equipped, remove the retainers, detach the connector, then remove the windshield wiper switch.
  8.  
  9. Installation is the reverse of the removal procedure.
  10.  

1990-96 Vehicles

See Figure 1

On 1990-96 vehicles, the wiper switch is a non-replaceable component of the multi-function turn signal lever. For multi-function lever removal and installation, refer to the following procedure.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the column housing cover end cap by pulling it toward the front of the vehicle.
  4.  
  5. Detach the electrical harness connector and grommet.
  6.  
  7. Pull toward the driver side door to release the detent/multi-function turn signal lever.
  8.  



Click image to see an enlarged view

Fig. Fig. 1: View of the multi-function lever, which includes the wiper switch

To install:
  1. Position the multi-function turn signal lever. Align the lever tab into the slot with the lever in the OFF position.
  2.  
  3. Attach the electrical harness connector and grommet.
  4.  
  5. Install the column housing cover end cap.
  6.  

 
label.common.footer.alt.autozoneLogo