GM Cutlass RWD 1970-1987 Repair Guide

Extension Housing Seal

Print

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Raise and properly support the vehicle.
  4.  
  5. Matchmark the driveshaft and remove it from the vehicle.
  6.  
  7. Carefully distort the seal with a punch and remove it from the extension housing. Be careful not to damage the housing.
  8.  

To install:
  1. Apply a non-hardening sealer on the outside of the new seal and drive the new seal into the housing using the proper tool.
  2.  
  3. Install the driveshaft with the marks aligned.
  4.  
  5. Lower the car and reconnect the negative battery cable.
  6.  

 
label.common.footer.alt.autozoneLogo