GM Cutlass RWD 1970-1987 Repair Guide

Wheel Assembly

Print

REMOVAL & INSTALLATION



See Figure 1

  1. If using a lug wrench, loosen the lug nuts slightly before raising the vehicle.
  2.  
  3. Raise the vehicle and support it safely.
  4.  
  5. Remove the lug nuts and wheel from the vehicle.
  6.  

To install:
  1. Install the wheel and hand tighten the lug nuts until they are snug.
  2.  
  3. Lower the vehicle and torque the lug nuts evenly to 80 ft. lbs (110 Nm).
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Wheel lug nut tightening sequence

INSPECTION



  1. Before putting on the wheels, check for any cracks on the wheels or enlarged bolt holes, remove any corrosion on the mounting surfaces with a wire brush. Installation of wheels without a good metal-to-metal contact at the mounting surface can cause wheel nuts to loosen. Recheck the wheels after 1000 miles of driving.
  2.  

 
label.common.footer.alt.autozoneLogo