GM: Electra/Park Avenue/Ninety-Eight 1990-1993

Speakers

Print

REMOVAL & INSTALLATION



Front Speaker/Amplifier Assembly


Click image to see an enlarged view

Fig. Fig. 1 Dash mounted front speaker service-1990 Electra/Park Avenue



Click image to see an enlarged view

Fig. Fig. 2 Dash mounted front speaker service-1990 Ninety-Eight



Click image to see an enlarged view

Fig. Fig. 3 Front door-mounted amplified speaker service; non-amplified units are similar

  1. Refer to the Air Bag section at the beginning of this Section, and disarm the Air Bag system.
  2.  
  3. If dash-mounted, remove the speaker grille (Ninety-Eight) or upper trim panel (Buick). If door-mounted, remove the door trim panel.
  4.  
  5. Remove the speaker (or speaker/amplifier assembly) mounting screws and pull away from the door.
  6.  
  7. Disconnect the wiring and remove. Disassemble as required.
  8.  

To install:

  1. Assemble the unit. Connect the wiring, position the assembly, then secure with screws.
  2.  
  3. Install the door panel, dash grille, or trim panel.
  4.  
  5. Check the units for proper operation.
  6.  
  7. Refer to the Air Bag section at the beginning of this Section, and arm the Air Bag system.
  8.  

Rear Speaker/Amplifier Assembly


Click image to see an enlarged view

Fig. Fig. 4 Rear speaker assembly attached to rear shelf



Click image to see an enlarged view

Fig. Fig. 5 Rear amplified speaker assembly attached to rear shelf

  1. Open the trunk.
  2.  
  3. Disconnect the connector(s).
  4.  
  5. Support the unit and remove the retaining nuts from the speaker or speaker/amplifier assembly.
  6.  
  7. Remove from the trunk area; disassemble as required.
  8.  

To install:

  1. Assemble the unit. Position the assembly, then secure with screws.
  2.  
  3. Connect the connector(s).
  4.  
  5. Check the units for proper operation.
  6.  

 
label.common.footer.alt.autozoneLogo