GM: Electra/Park Avenue/Ninety-Eight 1990-1993

Doors

Print



Click image to see an enlarged view

Fig. Fig. 1 Front door hinge assembly; rear hinges are similar

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the door trim panel and water deflector.
  4.  
  5. Disconnect all electrical connections to electrical components in the door.
  6.  
  7. Remove the rubber conduit and wiring harness from the door.
  8.  
  9. Support the door with a jack positioned at the rear of the door.
  10.  
  11. With the aid of an assistant, remove the door-to-hinge nuts and remove the door from the hinge.
  12.  

To install:

  1. With the aid of an assistant, install the door to the hinge and support the door with a jack positioned at the rear of the door.
  2.  
  3. Tighten the door-to-hinge nuts. To adjust the door alignment, loosen the nuts and reposition the door until proper alignment is attained. Ream the stud holes in the pillar side of the hinges if required to gain additional adjusting capability. When adjustment is satisfactory, torque the hinge nuts to 35 ft. lbs. (47 Nm).
  4.  
  5. Install the rubber conduit and wiring harness from the door.
  6.  
  7. Connect all electrical connections to electrical components in the door.
  8.  
  9. Install the water deflector and the door trim panel.
  10.  
  11. Connect the negative battery cable.
  12.  

 
label.common.footer.alt.autozoneLogo