GM Firebird 1982-1992 Repair Guide

Blower Motor

Print

REMOVAL & INSTALLATION



See Figures 1, 2, 3 and 4

  1. Disconnect the negative battery cable. If necessary, remove the diagonal fender brace at the right rear corner of the engine compartment to gain access to the blower motor.
  2.  
  3. Disconnect the electrical wiring from the blower motor. If equipped with air conditioning, remove the blower relay and bracket as an assembly and swing them aside.
  4.  
  5. Remove the blower motor cooling tube.
  6.  
  7. Remove the blower motor retaining screws.
  8.  
  9. Remove the blower motor and fan as an assembly from the case.
  10.  

To install:
  1. Position the blower motor into place and install the retaining screws.
  2.  
  3. Install the blower motor cooling tube.
  4.  
  5. Connect all the electrical connections.
  6.  
  7. Connect the negative battery cable.
  8.  



Click image to see an enlarged view

Fig. Fig. 1: Blower motor case assembly



Click image to see an enlarged view

Fig. Fig. 2: Disconnect the blower motor electrical connector by pulling it straight out



Click image to see an enlarged view

Fig. Fig. 3: Removing the blower motor attaching bolts



Click image to see an enlarged view

Fig. Fig. 4: Be sure to remove the blower motor cooling tube before removing the motor from the case

 
label.common.footer.alt.autozoneLogo