REMOVAL & INSTALLATION
Remove/reinstall only one lower control arm at a time. If both arms are removed at the same time, the axle could roll or slip sideways, making reinstallation of the arms very difficult.
- Raise the rear of the vehicle, place jackstands under the rear axle, then lower the jack so that the stands are supporting all of the weight.
- Remove the control arm attaching fasteners, then remove the control arm.
- Installation is a simple matter of bolting the arm into place. Torque the 3 bolts at the body brace bracket to 35 ft. lbs. (47 Nm) and the nut at the body bracket to 61 ft. lbs. (83 Nm).