GM Full-Size Trucks 1970-1979 Repair Guide

Ignition Module

Print

REMOVAL & INSTALLATION



See Figures 1 and 2

  1. Remove the distributor cap and rotor as outlined in Routine Maintenance of this guide.
  2.  
  3. Disconnect the harness connector and pick-up coil spade connectors from the module. Be careful not to damage the wires when removing the connector.
  4.  
  5. Remove the two screws and module from the distributor housing.
  6.  
  7. Coat the bottom of the new module with dielectric lubricant supplies with the new module. Reverse the above procedure to install.
  8.  



Click image to see an enlarged view

Fig. Fig. 1: View of the ignition module removed from the distributor



Click image to see an enlarged view

Fig. Fig. 2: Be sure to coat the mating surfaces of the module

 
label.common.footer.alt.autozoneLogo