GM Full-Size Trucks 1980-1987 Repair Guide
REMOVAL & INSTALLATION
Using a Holding Bar Tool J-8614-1, attached to the pinion shaft flange, remove the self locking nut and washer from the pinion shaft.
Install Tool J-8614-2, and 3 into the holding bar and remove the flange from the drive pinion. Remove the drive pinion from the carrier.
With a long drift, tap on the inner race of the outer pinion bearing to remove the seal.
Install the oil seal, gasket and using Tool J-22804 install the oil seal.
Install the flange, washer and nut and torque the nut to 270 ft. lbs.