GM Full-Size Trucks 1988-1998 Repair Information

Module

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Remove the distributor cap and rotor as previously described.
  2.  
  3. Disconnect the harness connector and pickup coil spade connectors from the module. Be careful not to damage the wires when removing the connector.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Be sure to coat the mating surfaces with silicone lubricant

  1. Remove the two screws and module from the distributor housing.
  2.  
  3. Coat the bottom of the new module with dielectric silicone lubricant. This is usually supplied with the new module. Reverse the above procedure to install.
  4.  

 
label.common.footer.alt.autozoneLogo