GM Full-Size Trucks 1988-1998 Repair Information

Power Door Lock Actuator

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the door trim panel and the water shield.
  4.  
  5. Remove the module panel.
  6.  



Click image to see an enlarged view

Fig. Fig. 1: Power door lock actuator-C/K Series

  1. Locate the actuator mounting rivets and drill them out.
  2.  
  3. Disconnect the remote lock rod from the actuator arm.
  4.  
  5. Disconnect the wiring harness and remove the actuator from the panel.
  6.  

To install:
  1. Install the actuator and pop in new rivets.
  2.  
  3. Connect the wiring harness and lock rod.
  4.  
  5. Install the module and the water shield.
  6.  
  7. Install the door panel and connect the battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo