GM Full Size Vans 1967-1986 Repair Guide

Ignition Module

Print

REMOVAL & INSTALLATION



See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Installing the ignition module

  1. Remove distributor cap and rotor.
  2.  
  3. Remove two module attaching screws, and capacitor attaching screw. Lift module, capacitor and harness assembly from base.
  4.  
  5. Disconnect wiring harness from module.
  6.  
  7. Check module with approved module tester.
  8.  
  9. Install module, wiring harness, and capacitor assembly. Use silicone lubricant on housing under module.
  10.  

 
label.common.footer.alt.autozoneLogo