GM Full Size Vans 1967-1986 Repair Guide

Door Panels

Print

Door Handle Clip Remover, tool J-9886-01 or equivalent, is required to perform the following procedure.

REMOVAL & INSTALLATION



See Figures 1 through 7



Click image to see an enlarged view

Fig. Fig. 1: Using a regulator clip tool, disengage the door handle



Click image to see an enlarged view

Fig. Fig. 2: Remove the handle and clip



Click image to see an enlarged view

Fig. Fig. 3: Unfasten the armrest retaining screws ...



Click image to see an enlarged view

Fig. Fig. 4: ... then remove the armrest



Click image to see an enlarged view

Fig. Fig. 5: Unfasten the door panel retaining screws ...



Click image to see an enlarged view

Fig. Fig. 6: ... then remove the door panel



Click image to see an enlarged view

Fig. Fig. 7: Removing the clip retained inside the door handle

  1. Remove the window regulator handle using tool J-9886-01.
  2.  
  3. Remove the window regulator handle bezel.
  4.  
  5. Remove the door lock assembly handle using J-9886-01.
  6.  
  7. Remove the control assembly handle bezel.
  8.  
  9. Remove the assist handle (if equipped).
  10.  
  11. Remove the armrest (if equipped).
  12.  
  13. Remove the door trim outer panel screws and pull the panel away from the retainer.
  14.  
  15. Remove the door trim inner panel screws and remove the trim inner panel.
  16.  
  17. Installation is the reverse of the removal procedure.
  18.  

 
label.common.footer.alt.autozoneLogo