GM Full Size Vans 1987-1997 Repair Guide

Early Fuel Evaporation System



See Figures 1 and 2

The EFE system, used on carbureted models, consists of an EFE valve at the flange of the exhaust manifold, an actuator, and a thermal vacuum switch. The TVS is located in the coolant outlet housing and directly controls vacuum.

In both systems, manifold vacuum is applied to the actuator which, in turn, closes the EFE valve. This routes hot exhaust gases to the base of the carburetor. When coolant temperatures reach a set limit, vacuum is denied to the actuator, allowing an internal spring to return the actuator to its normal position, opening the EFE valve.

Click image to see an enlarged view

Fig. Fig. 1: EFE valve and actuator - V6 and V8 engines

Click image to see an enlarged view

Fig. Fig. 2: Thermal vacuum switch for the EFE system


  1. Locate the EFE valve on the exhaust manifold and not the position of the actuator arm. On some vehicles, the valve and arm are covered by a two-piece cover which must be removed for access. Make sure the engine is overnight cold.
  3. Watch the actuator arm when the engine is started. The valve should close when the engine is started cold; the actuator link will be pulled into the diaphragm housing.
  5. If the valve does not close, stop the engine. Remove the hose from the EFE valve and apply 10 in. Hg of vacuum by hand pump. The valve should close and stay closed for at least 20 seconds (you will hear it close). If the valve opens in less than 20 seconds, replace it. The valve could also be seized if it does not close; lubricate it with spray type manifold heat valve lube. If the valve does not close when vacuum is applied and when it is lubricated, replace the valve.
  7. If the valve closes, the problem is not with the valve. Check for loose, cracked, pinched or plugged hoses, and replace as necessary. Test the EFE solenoid (located on the valve cover bracket); if it is working, the solenoid plunger will emit a noise when the current is applied.
  9. Warm up the engine to operating temperature.
  11. Watch the EFE valve to see if it has opened. It should now be open. If the valve is still closed, replace the solenoid if faulty, and/or check the engine thermostat; the engine coolant may not be reaching normal operating temperature.


If the vehicle is equipped with an oxygen sensor, it is located near the EFE valve. Use care when removing the EFE valve, as not to damage the oxygen sensor.

  1. Disconnect the negative battery cable and vacuum hose at the EFE valve.
  3. Remove the exhaust pipe-to-manifold nuts, and the washers and tension springs, if used.
  5. Lower the exhaust crossover pipe. On some models, complete removal of the pipe is not necessary.
  7. Remove the EFE valve.

To install:
  1. Installation is the reverse of removal. Always install new seals and gaskets. Tighten the exhaust nuts to 22 ft. lbs. (30 Nm). Connect the negative battery cable and vacuum hose to the valve.