GM Grand Am/Achieva/Calais/Skylark/Somerset 1985-98

Electronic Control Unit (ECU)/Electronic Brake Control Module (EBCM)

Print

REMOVAL & INSTALLATION



See Figure 1

Click image to see an enlarged view

Fig. Fig. 1: Electronic Brake Control Module (EBCM) mounting

  1. Disconnect the negative battery cable.
  2.  
  3. Detach the Electronic Control Unit (ECU)/Electronic Brake Control Module (EBCM) electrical connectors.
  4.  
  5. Unfasten the hex head screws attaching the ECU/EBCM to the dash panel.
  6.  
  7. Remove the ECU from the dash panel.
  8.  

To install:
  1. Ensure that the three plastic grommets are properly located.
  2.  
  3. Position the ECU/EBCM to the dash panel, aligning the screw holes.
  4.  
  5. Fasten the retaining hex head screws attaching the ECU/EBCM. Tighten the screws to 17 ft. lbs. (21 Nm).
  6.  
  7. Attach the electrical connectors.
  8.  
  9. Connect the negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo