GM Lumina/Grand Prix/Cutlass Supreme/Regal 1988-1996

Electronic Brake Control Module (EBCM)

Print

REMOVAL & INSTALLATION



1992-93 Vehicles

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Location of EBCM - 1992-93 vehicles shown

  1. Disconnect the negative battery cable.
  2.  
  3. Raise and safely support the vehicle.
  4.  
  5. Remove the left front wheel and tire assembly.
  6.  
  7. Remove the screws retaining the inner fender shield.
  8.  
  9. Unfasten the screw retaining the Electromagnetic Compatibility (EMC) shield. Slide the EMC shield back on the harness, making sure not to damage it.
  10.  
  11. Remove the screws retaining the EBCM, then slide the EBCM from the bracket.
  12.  
  13. Detach the connectors from the EBCM.
  14.  

To install:
  1. Attach the electrical connectors to the EBCM.
  2.  
  3. Slide the EBCM into the bracket, making sure the back guide pin is in its groove.
  4.  
  5. Install the hex-head screws securing the EBCM and tighten to 14 inch lbs. (2 Nm).
  6.  
  7. Inspect the EMC shield, and replace if damaged or torn. Slide the EMC shield over the harness and install the retaining screw. Tighten the screw to 13 inch lbs. (1.5 Nm).
  8.  
  9. Install the inner fender shield and secure with the retaining screws.
  10.  
  11. Install the left front wheel and tire assembly, then carefully lower the vehicle.
  12.  
  13. Connect the negative battery cable.
  14.  

1994-96 Vehicles

See Figure 2

Click image to see an enlarged view

Fig. Fig. 2: Electronic Brake Control Module (EBCM) mounting-1995 vehicle shown

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the glove compartment.
  4.  
  5. Remove the EBCM from the EBCM bracket, using the pressure tabs to release the EBCM.
  6.  
  7. Detach the EBCM electrical connectors.
  8.  

To install:
  1. Attach the EBCM electrical connector.
  2.  
  3. Install the EBCM into the bracket. Slide the EBCM into the bracket until secured by the pressure tabs.
  4.  
  5. Install the glove compartment assembly.
  6.  
  7. Connect the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo