See Figure 1
The six-way power seat adjusters are actuated by three 12V, reversible permanent magnet motors with built in circuit breakers. The motors drive the front and rear vertical gearnuts and a horizontal actuator. When the adjusters are at their limit of travel, an overload relay provides stall tighten so the motors are not overloaded. Each motor can be serviced as a separate unit.
REMOVAL & INSTALLATION
- Disconnect the negative battery cable.
- Remove the seat assembly from the vehicle as outlined in this section.
- Remove the adjuster assembly from the seat.
- Remove the feed wires from the motor.
- Remove the nuts securing the front of the motor support bracket-to-inboard adjuster. Partially withdraw the assembly from the adjuster and gearnut drives.
- Remove the drive cables from the motor. Completely disassemble the support bracket with the motors attached.
- Grind OFF the peened over ends of the grommet assembly securing the motor-to-support. Separate the motor from the support.
- Drill out the top end of the grommet assembly using a 3 / 16 in. (5mm) drill bit.
- Install the grommet assembly-to-motor support bracket. Secure the motor with a 3 / 16 in. (5mm) rivet.
- Install the drive cables.
- Install the motor-to-inboard adjuster.
- Connect the motor feed wires and negative battery cable.
- Install the adjuster assembly-to-seat bottom.
- With an assistant, install the seat and check for proper operation.