GM Lumina/Silhouette/Transport APVs 1990-1999 Repair Guide

Radio Receiver/Player in Dash

Print

REMOVAL AND INSTALLATION



See Figures 1 through 10


CAUTION
Some models covered by this guide may be equipped with a Supplemental Inflatable Restraint (SIR), which uses an air bag. Whenever working near any of the SIR components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SIR, as described in this section.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the steering column opening filler panel.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Remove the driver side and...



Click image to see an enlarged view

Fig. Fig. 2: ...passenger side lower dash panels



Click image to see an enlarged view

Fig. Fig. 3: Remove the lower steering column trim panel...



Click image to see an enlarged view

Fig. Fig. 4: ...then, remove the center console retaining screws...



Click image to see an enlarged view

Fig. Fig. 5: ...including the two hidden behind the glove box door



Click image to see an enlarged view

Fig. Fig. 6: Slide the center console off...

  1. Remove the right side sound insulator panel.
  2.  
  3. Remove the accessory trim panel.
  4.  
  5. Loosen the two nuts at the bottom of the radio.
  6.  



Click image to see an enlarged view

Fig. Fig. 7: ...to gain access to the radio attaching hardware. Loosen the two nuts at the bottom of the radio



Click image to see an enlarged view

Fig. Fig. 8: Remove the two screws attaching the radio bracket to the insturment panel lower trim pad assembly

  1. Remove the two screws attaching the radio bracket to the instrument panel lower trim pad assembly.
  2.  
  3. Slide the radio assembly out from the accessory housing.
  4.  
  5. Disconnect the antenna lead-in cable from the radio.
  6.  
  7. Disconnect the instrument panel electrical harness connectors from the radio and remove the radio assembly.
  8.  



Click image to see an enlarged view

Fig. Fig. 9: Slide the radio out of the dash



Click image to see an enlarged view

Fig. Fig. 10: Detach the electrical connector and the antenna plug

To install:
  1. Connect the instrument panel electrical harness connectors and the antenna lead-in cable to the radio.
  2.  
  3. Slide the radio assembly into the accessory housing.
  4.  
  5. Install the two screws attaching the radio bracket to the instrument panel lower trim pad assembly.
  6.  
  7. Tighten the two nuts at the bottom of the radio.
  8.  
  9. Install the accessory trim panel.
  10.  
  11. Install the right side sound insulator panel.
  12.  
  13. Install the steering column opening filler panel.
  14.  
  15. Connect the negative battery cable.
  16.  

 
label.common.footer.alt.autozoneLogo