GM Lumina/Silhouette/Transport APVs 1990-1999 Repair Guide

Speakers

Print

REMOVAL AND INSTALLATION



Front Door

CAUTION
Some models covered by this guide may be equipped with a Supplemental Inflatable Restraint (SIR), which uses an air bag. Whenever working near any of the SIR components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SIR, as described in this section.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the front door trim panel.
  4.  
  5. Remove the front door water deflector.
  6.  
  7. To remove the speaker from the door frame, depress the retaining clip and pull the speaker forward.
  8.  
  9. Detach the wire harness connector from the speaker.
  10.  
  11. Remove the speaker.
  12.  

See Figures 1, 2, 3 and 4

Click image to see an enlarged view

Fig. Fig. 1: To remove the front speaker, first remove the door panel ...



Click image to see an enlarged view

Fig. Fig. 2: ... as well as the weather sheet to access the inner door



Click image to see an enlarged view

Fig. Fig. 3: After unclipping the speaker, carefully pull the speaker forward to gain access to the harness connector



Click image to see an enlarged view

Fig. Fig. 4: Detach the speaker's electrical connector and remove the speaker from the door

To install:
  1. Attach the wire harness connector and install the speaker to the door.
  2.  
  3. Install the weather sheet (duct tape can help if it's torn).
  4.  
  5. Install the door panel.
  6.  

Rear Liftgate

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the liftgate trim panel.
  4.  
  5. Remove the rear radio speaker by pushing on the top tab and pulling the speaker form the liftgate.
  6.  
  7. Detach the electrical connector from the rear radio speaker.
  8.  

See Figure 5

Click image to see an enlarged view

Fig. Fig. 5: Exploded view of the rear liftgate speaker assembly

To install:
  1. Install the electrical connector to the rear radio speaker.
  2.  
  3. Install the rear radio speaker by inserting the tabs into the lower slots and pushing the upper tab into the slot.
  4.  
  5. Install the liftgate trim panel.
  6.  
  7. Connect the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo