GM Lumina/Silhouette/Transport APVs 1990-1999 Repair Guide

Roller Brackets

Print

REMOVAL AND INSTALLATION



Center
  1. Scribe the location of the existing brackets on the door.
  2.  
  3. Support the door, remove the bracket bolts from the door, and remove the bracket and roller assembly.
  4.  
  5. Remove the pin from the bracket and roller assembly and remove the bracket.
  6.  

See Figures 1 and 2

Click image to see an enlarged view

Fig. Fig. 1: Typical rear sliding door sliding center track and cover



Click image to see an enlarged view

Fig. Fig. 2: View of the sliding door center track roller bracket mounting

To install:
  1. Install the pin to the bracket and roller assembly.
  2.  
  3. Install the bracket and roller assembly to the track.
  4.  
  5. Install the bracket bolts to the door, adjust the door to properly fit the door frame and tighten the bolts to 20 ft. lbs. (27 Nm).
  6.  

Upper

  1. Remove the inner door trim panel and garnish molding.
  2.  
  3. Support the door, remove the bracket to door screws, and remove the bracket.
  4.  
  5. Installation is the reverse of the removal procedure.
  6.  

Lower

See Figure 3

Click image to see an enlarged view

Fig. Fig. 3: Exploded views of the sliding side door, including the upper and lower roller bracket

  1. Remove the door inner trim panel, as outlined later in this section.
  2.  
  3. Scribe the location of the existing bracket on the door.
  4.  
  5. Remove the bracket-to-door bolts.
  6.  
  7. Disconnect the catch cable from the bracket.
  8.  
  9. Remove the lower striker, then remove the lower roller bracket.
  10.  
  11. Installation is the reverse of the removal procedure.
  12.  

 
label.common.footer.alt.autozoneLogo