GM Malibu/Cutlass 1997-2000

Flashers

Print

REPLACEMENT



The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.

  1. Remove the bezel from the ignition switch.
  2.  



Click image to see an enlarged view

Fig. Remove the bezel from the ignition switch

  1. Carefully remove the instrument panel accessory trim plate.
  2.  



Click image to see an enlarged view

Fig. To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .



Click image to see an enlarged view

Fig. . . . then gently pull the accessory trim plate away

  1. Detach the electrical connector from the hazard warning switch.
  2.  



Click image to see an enlarged view

Fig. Unplug the electrical connector from the hazard warning switch . . .

  1. Unfasten the screw securing the hazard warning switch and remove the switch.
  2.  



Click image to see an enlarged view

Fig. . . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle

  1. Installation is the reverse of removal.
  2.  



Click image to see an enlarged view

Fig. Left dash end cap fuse and wiring harness junction block



Click image to see an enlarged view

Fig. Right dash end cap fuse and wiring harness junction block



Click image to see an enlarged view

Fig. Underhood fuse and electrical junction block (1 of 2)



Click image to see an enlarged view

Fig. Fuse/circuit breaker identification (2 of 2)

 
label.common.footer.alt.autozoneLogo