GM Malibu/Cutlass 1997-2000

Throttle Position (TP) Sensor

Print

OPERATION



The Throttle Position (TP) sensor is a potentiometer that provides a signal to the PCM which is directly proportional to the throttle plate position. The TP sensor is mounted on the side of the throttle body and is connected to the throttle plate shaft. The TP sensor monitors throttle plate movement and position, and transmits an appropriate electrical signal to the PCM. These signals are used by the PCM to adjust the air/fuel mixture, spark timing and EGR operation according to engine load at idle, part throttle, or full throttle. The TP sensor is not adjustable.

The TP sensor receives a 5 volt reference signal and a ground circuit from the PCM. A return signal circuit is connected to a wiper that runs on a resistor internally on the sensor. The further the throttle is opened, the wiper moves along the resistor, at wide open throttle, the wiper essentially creates a loop between the reference signal and the signal return returning the full or nearly full 5 volt signal back to the PCM. At idle, the signal return should be approximately 0.9 volts.

TESTING



  1. With the engine OFF and the ignition ON , check the voltage at the signal return circuit of the TP sensor by carefully backprobing the connector using a DVOM. Attach the black lead to known good ground, the red lead to terminal B .
  2.  
  3. Voltage should be between 0.2 and 1.4 volts at idle.
  4.  
  5. Slowly move the throttle pulley to the Wide Open Throttle (WOT) position and watch the voltage on the DVOM. The voltage should slowly rise to slightly less than 4.8v at Wide Open Throttle (WOT).
  6.  
  7. If no voltage is present, check the wiring harness for supply voltage (5.0v) and ground (0.3v or less), by referring to your corresponding wiring guide in . If supply voltage and ground are present, but no there is no output voltage from the TP sensor, replace the sensor. If supply voltage and ground do not meet specifications, make necessary repairs to the harness or PCM.
  8.  

REMOVAL & INSTALLATION





Click image to see an enlarged view

Fig. The TP sensor assembly on the 2.4L consists of the mounting screws (1), the sensor (2), and the O-ring



Click image to see an enlarged view

Fig. The TP sensor on the 3.1L engine is similar to the 2.4L, except for the connector

  1. Disconnect the negative battery cable.
  2.  
  3. On the 2.4L engine, remove the air cleaner outlet tube.
  4.  
  5. Unplug the TP sensor electrical connection.
  6.  
  7. Remove the two retaining screws and remove the TP sensor from the throttle body.
  8.  

To install:

  1. With the throttle plate full closed, carefully slide the rotary tangs on the sensor into position over the throttle shaft, then rotate the sensor counterclockwise to the align the bolt holes..
  2.  


WARNING
Failure to install the TP sensor in this manner may result in sensor damage or high idle speeds.

  1. Install and tighten the sensor mounting screws to 18-35 inch lbs. (2-4 Nm).
  2.  


NOTE
The TP sensor is not adjustable.

  1. Connect the wiring harness to the sensor.
  2.  
  3. On the 2.4L engine, install the air intake resonator.
  4.  
  5. Connect the negative battery cable.
  6.  

 
label.common.footer.alt.autozoneLogo