GM Metro/Sprint 1985-1993 Repair Guide

Brake Switch

Print

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the plastic cover from steering column, as required.
  4.  
  5. Disconnect the stop lamp switch electrical connector.
  6.  
  7. Depress the brake pedal and remove the locknut from the threaded portion of the brake light switch.
  8.  
  9. Remove the brake light switch.
  10.  

To install:
  1. Install brake light switch.
  2.  
  3. Adjust the switch so that the clearance between the end thread of the stoplight switch and the brake pedal contact plate is 0.02-0.04 in. (0.5-1.0mm) with the brake pedal pulled upward.
  4.  
  5. Depress brake pedal, install locknut and tighten to 115 inch lbs. (13 Nm).
  6.  
  7. Connect brake light switch electrical connector.
  8.  
  9. Install the plastic cover on steering column, as required.
  10.  
  11. Connect the negative battery cable.
  12.  

 
label.common.footer.alt.autozoneLogo