GM Metro/Sprint 1985-1993 Repair Guide

Servo Cable

Print

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Disconnect the servo cable from the servo unit.
  4.  
  5. Disconnect the servo unit from the throttle pedal.
  6.  
  7. Remove the servo cable from the engine compartment side.
  8.  
  9. Installation is the reverse of removal.
  10.  
  11. Lightly secure the servo cable casing so that there is a light tension on the servo cable, but make sure not to pull the throttle off the idle setting.
  12.  
  13. Tighten the clamp securely.
  14.  

 
label.common.footer.alt.autozoneLogo