GM Metro/Sprint 1985-1993 Repair Guide

Back-up Light Switch

Print

REMOVAL & INSTALLATION



See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Back-up lamp switch

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the back-up lamp switch electrical connector.
  4.  
  5. Remove the back-up lamp switch wire from retaining clamp.
  6.  
  7. Remove back-up lamp switch from case.
  8.  

To install:
  1. Using a new O-ring, install the back-up lamp switch. Tighten to 17 ft. lbs. (23 Nm).
  2.  
  3. Install the back-up lamp switch wire retaining clamp.
  4.  
  5. Install the back-up lamp switch electrical connector.
  6.  
  7. Connect the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo