GM Prizm/Nova 1985-1993 Repair Guide

Hydraulic Modulator Solenoid Assembly

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Disconnect the solenoid electrical connector.
  4.  
  5. Remove the 2 Torx® head bolts.
  6.  
  7. Remove the solenoid assembly.
  8.  

To install:
  1. Verify that the solenoid lip seal is properly positioned on the new solenoid.
  2.  
  3. Position the solenoid so the connectors face each other.
  4.  
  5. Press down firmly by hand until the solenoid assembly flange seats on the modulator assembly.
  6.  
  7. Install the 2 Torx® head bolts. Tighten to 40 inch lbs. (4.5 Nm).
  8.  
  9. Connect the solenoid electrical connector.
  10.  
  11. Properly bleed the brake system.
  12.  
  13. Connect the negative battery cable.
  14.  



Click image to see an enlarged view

Fig. Fig. 1: ABS-VI hydraulic modulator solenoid assembly

 
label.common.footer.alt.autozoneLogo