GM Prizm/Nova 1985-1993 Repair Guide

Cruise Control Module

Print

REMOVAL & INSTALLATION



1989-90
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the right side cowl trim.
  4.  
  5. Remove the glove box and trim assembly.
  6.  
  7. Remove the cruise control module from the vehicle.
  8.  
  9. Installation is the reverse of removal.
  10.  

1991-92
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the right side lower trim panel.
  4.  
  5. Remove the cruise control module from the vehicle.
  6.  
  7. Installation is the reverse of removal.
  8.  

1993

See Figure 1

  1. Disable the SRS (Air Bag) system as outlined at the beginning of this Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Unclip and set aside the left and right front carpet retainers.
  6.  
  7. Remove the glove box by removing the 4 bolts and 3 screws.
  8.  
  9. Remove the parking brake console by removing the five retaining screws.
  10.  
  11. Disconnect the hood release lever from the knee bolster.
  12.  
  13. Remove the trim caps.
  14.  
  15. Remove the knee bolster from the instrument panel by removing the 4 retaining bolts.
  16.  
  17. Remove the shift lever trim bezel.
  18.  
  19. Remove the package tray.
  20.  
  21. Remove the center trim bezel.
  22.  
  23. Disconnect the electrical connectors from the hazard lights, defogger and cigar lighter.
  24.  
  25. Remove the four screws and remove the radio.
  26.  
  27. Remove the 2 screws and remove the center console.
  28.  
  29. Remove the cruise control module by removing the 2 bolts and clip and disconnecting the module electrical connector.
  30.  

To install:
  1. Reposition the cruise control module, install the 2 bolts and clip and connect the module electrical connector.
  2.  
  3. Install the center console and 2 retaining screws.
  4.  
  5. Connect the radio electrical connector and install the 4 radio retaining screws.
  6.  
  7. Connect the electrical connectors to the hazard lights, defogger and cigar lighter.
  8.  
  9. Install the center trim bezel.
  10.  
  11. Install the package tray.
  12.  
  13. Install the shift lever trim bezel.
  14.  
  15. Install the knee bolster to the instrument panel with the 4 retaining bolts.
  16.  
  17. Install the trim caps.
  18.  
  19. Connect the hood release lever to the knee bolster.
  20.  
  21. Install the parking brake console with the five retaining screws.
  22.  
  23. Install the glove box and the 4 bolts and 3 screws.
  24.  
  25. Position and clip the left and right front carpet retainers.
  26.  
  27. Enable the SRS (Air Bag) system as outlined at the beginning of this Section.
  28.  
  29. Connect the negative battery cable.
  30.  



Click image to see an enlarged view

Fig. Fig. 1: Cruise control components - 1993

 
label.common.footer.alt.autozoneLogo