The Crankshaft Position (CKP) sensor provides a signal through the ignition module which the VCM uses as a reference to calculate rpm and crankshaft position.
See Figures 1 and 2
- Disconnect the CKP sensor harness. Connect an LED test light between battery ground and CKP harness terminal A .
- With the ignition ON and the engine off, verify that the test light illuminates.
- If not as specified, repair or replace the fuse and/or wiring.
- Carefully connect the test light between CKP harness terminal A and B . Verify that the test light illuminates.
- If not as specified, repair the CKP harness ground circuit (terminal B ).
- Turn the ignition OFF and disconnect the test light.
- Next, connect suitable jumper wires between the CKP sensor and CKP sensor harness. Connect a duty cycle meter to the jumper wire corresponding to CKP terminal C and battery ground.
- Crank the engine and verify that the duty cycle signal is between 40-60%.
- If it is not as specified, the CKP sensor may be faulty.
- Next, connect a AC volt meter to the jumper wire corresponding to CKP terminal C and battery ground.
- Crank the engine and verify that the AC voltage signal is at least 10.0 volts.
- If not as specified the CKP sensor may be faulty.
See Figures and 3 and 4
- Turn the ignition key OFF .
- Unplug the sensor electrical harness and check the terminals for corrosion and damage.
- Check the sensor wiring harness wires for continuity and repair as necessary.
- Attach the sensor harness making sure it is firmly engaged.
- Using a Digital Volt Ohm Meter (DVOM) set on the DC scale, backprobe the sensor signal terminal (terminal A) with the positive lead of the meter and backprobe the sensor ground terminal (terminal B) with the negative lead of the meter.
- Have an assistant crank the engine and observe the meter.
- You should have approximately a 5 volt reference signal pulse. If not the sensor may be defective.
REMOVAL & INSTALLATION
See Figures 5, 6, 7, 8 and 9
- Disconnect the negative battery cable.
- Raise the vehicle and support it with jackstands.
- If equipped on 4.3L engines, remove the steering linkage shield to access the sensor.
- Unplug the sensor harness connector at the sensor.