Diagnosis of a driveablility and/or emissions problems requires attention to detail and following the diagnostic procedures in the correct order. Resist the temptation to perform any repairs before performing the preliminary diagnostic steps. In many cases this will shorten diagnostic time and often cure the problem without electronic testing. The proper troubleshooting procedure for these vehicles is as follows:
This is possibly the most critical step of diagnosis and should be performed immediately after retrieving any codes. A detailed examination of connectors, wiring and vacuum hoses can often lead to a repair without further diagnosis. Performance of this step relies on the skill of the technician performing it; a careful inspector will check the undersides of hoses as well as the integrity of hard-to-reach hoses blocked by the air cleaner or other component. Wiring should be checked carefully for any sign of strain, burning, crimping, or terminal pull-out from a connector. Checking connectors at components or in harnesses is required; usually, pushing them together will reveal a loose fit.
If a fault occurs intermittently, such as a loose connector pin breaking contact as the vehicle hits a bump, the VCM will note the fault as it occurs and energize the dash warning lamp. If the problem self-corrects, as with the terminal pin again making contact, the dash lamp will extinguish after 10 seconds but a code will remain stored in the computer control module's memory. When an unexpected code appears during diagnostics, it may have been set during an intermittent failure that self-corrected; the codes are still useful in diagnosis and should not be discounted.
The fault codes and the scan tool data will lead to diagnosis and checking of a particular circuit. It is important to note that the fault code indicates a fault or loss of signal in an VCM-controlled system, not necessarily in the specific component. Refer to the appropriate Diagnostic Code chart to determine the codes meaning. The component may then be tested following the appropriate component test procedures found in this section. If the component is OK, check the wiring for shorts or opens. Further diagnoses should be left to an experienced driveability technician. If a code indicates the VCM to be faulty and the VCM is replaced, but does not correct the problem, one of the following may be the reason: