GM S10/S15/Sonoma Pick-Ups 1982-1993 Repair Manual

Door Locks

Print

REMOVAL & INSTALLATION



See Figures 1 through 5



Click image to see an enlarged view

Fig. Fig. 1: Disengaging/engaging the connecting rod retaining clip



Click image to see an enlarged view

Fig. Fig. 2: Exploded view of a common lock cylinder assembly mounting



Click image to see an enlarged view

Fig. Fig. 3: View of a common door lock assembly and components



Click image to see an enlarged view

Fig. Fig. 4: Exploded view of the early model outside door handle/lock assembly



Click image to see an enlarged view

Fig. Fig. 5: Exploded view of the early model inside door handle/lock assembly

Door Lock Assembly
  1. Remove the door trim panel. For details, please refer to the procedure earlier in this section.
  2.  
  3. If necessary, remove the water deflector.
  4.  

The water deflector is secured by a strip of adhesive between the deflector and door, as well as waterproof sealing tape. Upon installation, make sure a good seal is achieved to keep water from entering into the body. If necessary, use strip caulking as a sealant between the deflector and door.

  1. Remove the lock rods from the inner door handle housing.
  2.  
  3. Remove the outside handle lock rod from the lock assembly.
  4.  
  5. Remove the lock cylinder rod from the lock cylinder.
  6.  
  7. Remove the lock assembly-to-door retaining screws, then remove the assembly from the door.
  8.  
  9. Installation is the reverse of removal. Be sure to check the operation of the lock assembly before installing the door water deflector (if equipped) and trim panel.
  10.  

Lock Cylinder Assembly
  1. Remove the door trim panel. For details, please refer to the procedure earlier in this section.
  2.  
  3. For early model vehicles, remove the armrest bracket-to-door screws and the bracket from the door.
  4.  
  5. Remove the water deflector (if equipped) and roll up the window.
  6.  

The water deflector is secured by a strip of adhesive between the deflector and door, as well as waterproof sealing tape. Upon installation, make sure a good seal is achieved to keep water from entering into the body. If necessary, use strip caulking as a sealant between the deflector and door.

  1. Disconnect the actuator rod from the lock cylinder.
  2.  

On some late model vehicles, it may be easier to remove the lock cylinder retainer, then disconnect the linkage.

  1. Remove the lock cylinder-to-door retainer, then remove the lock cylinder and seal from the door.
  2.  
  3. Installation is the reverse of removal. Check the operation of the lock cylinder before installing the water deflector (if equipped) and the door trim panel.
  4.  

 
label.common.footer.alt.autozoneLogo