GM Storm/Spectrum 1985-1993 Repair Guide

Brake Pedal Assembly

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  



Click image to see an enlarged view

Fig. Fig. 1: Brake pedal assembly - Spectrum

  1. Remove the steering column assembly.
  2.  
  3. Disconnect the brake and clutch switch electrical connectors.
  4.  
  5. Disconnect the clutch cable from the clutch pedal, if so equipped.
  6.  
  7. Disconnect the fork clevis from the brake pedal.
  8.  
  9. Remove the brake pedal assembly-to-body mounting nuts. Remove the brake pedal assembly.
  10.  

To install:
  1. Install the brake pedal assembly to the vehicle in the correct position.
  2.  
  3. Tighten brake pedal assembly-to-body mounting nuts to 15 ft. lbs.
  4.  
  5. Connect the yoke clevis to the brake pedal.
  6.  
  7. Connect the clutch cable to the clutch pedal. Adjust the clutch pedal free-play, if so equipped.
  8.  
  9. Reconnect the brake and clutch switch electrical connectors.
  10.  
  11. Install the steering column assembly.
  12.  
  13. Check brake pedal height adjustment. Reconnect the negative battery cable.
  14.  
  15. Check the brake pedal, brake light switch and clutch pedal for proper operation.
  16.  

 
label.common.footer.alt.autozoneLogo