GM Storm/Spectrum 1985-1993 Repair Guide

Control Lever Assembly

Print

REMOVAL & INSTALLATION



Spectrum

See Figure 1

  1. Disconnect the negative battery cable.
  2.  



Click image to see an enlarged view

Fig. Fig. 1: Control lever assembly - Spectrum

  1. Remove the control lever knobs.
  2.  
  3. Remove the control assembly lens and disconnect the bulb.
  4.  
  5. Disconnect the control cables at the blower assembly and the heater assembly.
  6.  
  7. Remove the control assembly fasteners.
  8.  
  9. Pull the control assembly from the instrument panel and disconnect the electrical connection.
  10.  
  11. Disconnect the control cables from the control lever assembly.
  12.  
  13. Remove the blower switch.
  14.  
  15. Remove the A/C switch, if equipped.
  16.  
  17. Remove the heater switch.
  18.  

To install:
  1. Install the heater switch, A/C switch, if equipped, and the blower switch.
  2.  
  3. Connect the control cables to the control lever assembly and adjust the cables.
  4.  
  5. Connect the electrical connection to the control assembly and install the assembly to the instrument panel.
  6.  
  7. Install the control assembly fasteners.
  8.  
  9. Connect and adjust the control cables to the blower assembly and the heater assembly.
  10.  
  11. Connect the bulb and install the control assembly lens.
  12.  
  13. Install the control lever knobs.
  14.  
  15. Connect the negative battery cable.
  16.  

Storm

See Figure 2

  1. Disconnect the negative battery cable.
  2.  



Click image to see an enlarged view

Fig. Fig. 2: Control lever assembly - Storm

  1. Remove the console and the glove box.
  2.  
  3. Remove the control cables at the blower assembly and the heater assembly.
  4.  
  5. Remove the four screws attaching the control lever assembly.
  6.  
  7. Remove the control lever assembly.
  8.  
  9. Disconnect the A/C, if equipped, and blower switch connectors.
  10.  
  11. Remove the control lever assembly.
  12.  

To install:
  1. Connect the A/C, if equipped, and the blower switch connectors.
  2.  
  3. Install the control lever assembly.
  4.  
  5. Install the four screws attaching the control lever assembly.
  6.  
  7. Connect and adjust the control cables at the blower assembly and the heater unit.
  8.  
  9. Install the glove box and the console.
  10.  
  11. Connect the negative battery cable.
  12.  

 
label.common.footer.alt.autozoneLogo