GM Storm/Spectrum 1985-1993 Repair Guide

Ignition Lock Cylinder

Print

REMOVAL & INSTALLATION



Spectrum
  1. Remove the negative battery cable.
  2.  
  3. Remove the steering wheel and the steering cowl by removing the screws under the cowl. Remove the combination switch.
  4.  
  5. Disconnect the switch wires at the connectors.
  6.  
  7. Remove the two screws attaching the ignition and starter switch. Remove the switch.
  8.  
  9. Turn the key to the OFF position, depress the retaining pin and remove the ignition lock cylinder from the switch.
  10.  

To install:
  1. Install the lock cylinder into the switch.
  2.  
  3. Install the starter switch and the two screws attaching the switch to the ignition.
  4.  
  5. Connect the switch wires at the connectors.
  6.  
  7. Install the combination switch.
  8.  
  9. Install the steering cowl and tighten the screws underneath.
  10.  
  11. Install the steering wheel.
  12.  

Storm

If equipped with an air bag system, disable the system prior to starting the repair procedure. If not disabled, accidental deployment and personal injury may occur.

  1. Remove the negative battery cable.
  2.  
  3. Remove the steering wheel.
  4.  
  5. Remove the combination switch assembly.
  6.  
  7. Turn the key to the OFF position, depress the retaining pin and remove the ignition lock cylinder from the switch.
  8.  

To install:
  1. Install the lock cylinder into the switch.
  2.  
  3. Install the turn signal switch screws and the turn signal switch.
  4.  
  5. Install the four screws and the coil assembly to the turn signal switch.
  6.  
  7. Connect the coil assembly wiring harness to the turn signal switch.
  8.  
  9. Install the two piece steering column cover and the two piece steering column cover screws.
  10.  
  11. Raise the steering column and install the upper steering column mounting bolts. Tighten the bolts to 18 ft. lbs. (24 Nm).
  12.  
  13. Install the left lower dash trim panel and tighten the lower dash trim panel screws.
  14.  
  15. Install the lap air deflector and tighten the lap air deflector screws.
  16.  
  17. Install the knee pad assembly and tighten the five screws, the bolt and the nut attaching the assembly.
  18.  
  19. Install the engine hood opener cable.
  20.  
  21. Install the engine hood opener and tighten the two screws.
  22.  
  23. Connect the electrical connector to the cigar lighter bezel and install the bezel.
  24.  
  25. Connect the electrical connector to the left switch bezel and install the bezel.
  26.  
  27. Install the steering wheel.
  28.  
  29. Connect the negative battery terminal to the battery.
  30.  

 
label.common.footer.alt.autozoneLogo