Grand Cherokee 2006-2007

Multi-Function (Combination) Switch

Print

Removal & Installataion



  1. Disconnect and isolate the battery negative cable.
    WARNING
    Wait two minutes for the airbag system reserve capacitor to discharge before performing further diagnosis or service.

  2.  
  3. From below the steering column, remove the three screws that secure the lower steering column shroud to the multi-function switch mounting housing.
  4.  
  5. Using hand pressure, push gently inward on both sides of the upper shroud near the parting line between the upper and lower shrouds to release the snap features that secure the two shroud halves together.
  6.  
  7. Remove both the upper and lower shrouds from the steering column.
  8.  
  9. Remove the Steering Control Module (SCM) from the steering column.
  10.  
  11. Remove the two screws that secure the left multifunction switch to the SCM .
  12.  
  13. Disengage the two retaining tabs , next to the screw mounts that secure the left multi-function switch to the SCM.
  14.  
  15. Disconnect the left multi-function switch from the SCM.
  16.  

To install:

  1. Position the left multi-function switch onto position on the Steering Control Module (SCM) .
  2.  
  3. Engage the two retaining tabs, next to the screw mounts that secure the left multi-function switch and firmly snap into place.
  4.  
  5. Install the two screws that secure the left multifunction switch to the SCM. Tighten the screws to 22 inch lbs. (2.5 Nm).
  6.  
  7. Position the lower steering column shroud to the underside of the steering column.
  8.  
  9. Install the three screws that secure the lower steering column shroud to the multi-function switch mounting housing. Tighten the screws to 17 inch lbs. (2 Nm).
  10.  
  11. Position the upper column shroud over the steering column with the hazard warning switch button inserted through the hole in the upper shroud.
  12.  
  13. Align the snap features on the upper and lower shrouds and apply hand pressure to snap them together.
  14.  
  15. Reconnect the battery negative cable.
  16.  

 
label.common.footer.alt.autozoneLogo