GrandPrix, Impala 2006-2008, Monte Carlo 2006-2007

Control Links

Print

Removal & Installation




NOTE
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Raise and support the vehicle.
  2.  
  3. Remove the stabilizer shaft link nut from the stabilizer shaft link and the stabilizer shaft.
  4.  
  5. Remove the stabilizer shaft link nut from the stabilizer shaft link and the strut.
  6.  
  7. Remove the stabilizer shaft link from the vehicle.
  8.  
  9. To install, reverse removal procedure.
  10.  
  11. Tighten the following to specification:

    Stabilizer shaft link nut to the stabilizer shaft link and stabilizer shaft: 37 ft .lbs. (50 Nm).
     
    Stabilizer shaft link nut to the stabilizer shaft link and the strut: 37 ft .lbs. (50 Nm).
     

  12.  

 
label.common.footer.alt.autozoneLogo