H3 2006

Driven Disc & Pressure Plate

Print

Removal & Installation



  1. Remove the transmission.
  2.  
  3. Remove the clutch pressure plate bolts. Discard the bolts.

    Click image to see an enlarged view

    Fig. Exploded view of clutch assembly

  4.  
  5. Remove the clutch pressure plate and driven disc from the dowel pins on the flywheel.
  6.  

To install:

  1. Install the clutch pressure plate and driven plate to the dowel pins on the flywheel.
  2.  
  3. Install the clutch pressure plate bolts finger tight.
  4.  
  5. Use the Snap-On A145 Clutch Aligner Set, or equivalent, to align the clutch driven plate to the clutch pilot bearing.
  6.  
  7. Tighten the NEW clutch pressure plate bolts in the sequence shown.

    Click image to see an enlarged view

    Fig. Tighten the NEW clutch pressure plate bolts in the sequence shown

    1. Tighten the clutch pressure plate bolts in sequence to 15 ft. lbs. (20 Nm).
    2.  
    3. Use the J 36660-A in order to tighten the clutch pressure plate bolts in sequence an additional 45 degrees.
    4.  

  8.  
  9. Install the transmission.
  10.  

 
label.common.footer.alt.autozoneLogo