H3 2006

Ignition Lock Cylinder

Print

Removal & Installation



  1. Remove the steering column trim covers.
  2.  
  3. Turn the ignition lock cylinder to the Accessory (ACC) position.
  4.  
  5. The ignition lock cylinder access hole is just under the inflatable restraint steering wheel module coil on the right center of the steering column housing.
  6.  
  7. Insert the 90 degree tip of a pick type tool into the ignition lock cylinder access hole.
  8.  
  9. Push down and hold the ignition lock cylinder retaining pin.
  10.  
  11. Remove the ignition lock cylinder by pulling it out of the steering column.
  12.  

To install:

  1. Install the ignition lock cylinder by performing the following procedure:
    1. Turn the ignition lock cylinder to the ACC position.
    2.  
    3. Push the ignition lock cylinder until the ignition lock cylinder retaining pin locks in place.
    4.  

  2.  
  3. Install the steering column trim covers.
  4.  

 
label.common.footer.alt.autozoneLogo