H3 2006

Turn Signal (Multi-Function) Switch

Print

Removal & Installation




NOTE
The turn signal multifunction switch and Inflatable restraint steering wheel module coil are serviced as an assembly.

  1. Remove the steering wheel.
  2.  
  3. Remove the steering column trim covers.
  4.  
  5. Disconnect any electrical connectors and remove the wiring harness from any retainers as needed.

    Click image to see an enlarged view

    Fig. Disconnect any electrical connectors and remove the wiring harness from any retainers as needed

  6.  
  7. Remove the turn signal multifunction switch bolts.

    Click image to see an enlarged view

    Fig. Remove the turn signal multifunction switch bolts

  8.  
  9. Slide the multifunction turn signal switch off of the steering column.
  10.  

To install:


NOTE
A new multifunction turn signal switch will come pre-centered with a centering tab attached. Do NOT remove the centering tab until installation is complete. Failure to follow procedure will cause a misalignment of the multifunction turn signal switch and centering will be required. If reusing the existing multifunction turn signal switch, you must center it.

  1. Slide the multifunction turn signal switch onto the steering column.
  2.  
  3. Install the multifunction turn signal switch bolts.
  4.  
  5. Connect any electrical connectors and install the wiring harness through any retainers as needed.
  6.  
  7. Remove the centering tab from the multifunction turn signal switch.
  8.  
  9. Install the steering column trim covers.
  10.  
  11. Install the steering wheel.
  12.  

 
label.common.footer.alt.autozoneLogo