H3 2006

Rear Window Washer/Wiper Systems

Print

Removal & Installation



Wiper Motor

Specific to:

Hummer H3 2006-2010

  1. Remove the rear wiper arm.
  2.  
  3. Remove the jack stowage cover.
  4.  
  5. Remove the jack stowage tool kit.
  6.  
  7. Remove the 3 rear wiper motor mounting bolts.

    Click image to see an enlarged view

    Fig. Remove the 3 rear wiper motor mounting bolts (1) and the wiper motor (2)

  8.  
  9. Remove the rear wiper motor.
    1. Pull motor rearward to access washer hose and electrical connections, lower motor into endgate and remove from exterior pivot shaft grommet.
    2.  

  10.  
  11. Installation is the reverse of removal.
  12.  

Wiper Washer

Specific to:

Hummer H3 2006-2010

  1. Remove the 3 windshield washer solvent container mounting bolts.

    Click image to see an enlarged view

    Fig. Remove the 3 windshield washer solvent container mounting bolts (1) and the windshield washer solvent container (2)

  2.  
  3. Roll the container assembly forward.
  4.  
  5. Disconnect both washer pump electrical connectors.
  6.  
  7. Disconnect both washer pump jumper hoses at the air inlet grille panel connections, if equipped.
  8.  
  9. Contain any lost washer solvent fluid in a clean suitable container.
  10.  
  11. Disconnect and secure the coolant container overflow hose.
  12.  
  13. Remove the windshield washer solvent container assembly.
  14.  
  15. Disconnect the washer pump jumper hose from the washer pump spout.
  16.  
  17. Using 2 flat-bladed tools, pry the washer pump from the windshield washer solvent container.
  18.  
  19. Discard the washer pump container grommet.
  20.  
  21. Remove the rear window washer pump.

    Click image to see an enlarged view

    Fig. Remove the rear window washer pump (1)

  22.  
  23. Installation is the reverse of removal.
  24.  

 
label.common.footer.alt.autozoneLogo